
3. Wiring instructions
96 sensors must be connected to 96 channels, and each sensor must be in a three wire system. If two wires are required, A, B, and C wires must be connected. All 96 wires of A, B, and C wires must be connected to the input end of the instrument cabinet. The C wire output (connected to the instrument) of the instrument cabinet wiring board can be connected in parallel with 12 channels to form one channel. Eight 0.5-1mm2 copper core wires are used to connect to the C1~C4 of the four instrument sockets
4. The C terminal of the thermocouple and standard signal is not connected, and the wiring of the A and B terminals is the same as that of the resistance sensor above
5. Other terminal definitions for wiring are the same as the TDS-3200/4800/6400 backend wiring
6. Dimensions: 160 × 160 × 320mm; Hole size: 152 × 152 mm